Restore the strength and the straight lines
Wrought iron repair should preserve both structure and appearance. A repair that restores strength but leaves the panel line visibly uneven can stand out on a customer-facing property, pool enclosure, front elevation, or open-view fence line.
Pecos evaluates the damaged panel, posts on both sides, welds or mechanical connections, gate hardware, coating condition, and the way the repaired section meets the surrounding fence. Depending on the damage, the best repair may be a localized component replacement, a rebuilt gate opening, or a partial panel replacement.
Coating damage deserves attention because exposed steel can begin corroding even when the original impact did not significantly weaken the panel. Structural repair and finish protection should be considered together when bare steel is exposed.
Bent panels and broken connections need different fixes
A decorative picket bent by impact is not the same as a leaning post or a broken welded connection. We look at whether the damaged section can be restored cleanly or whether panel replacement would produce a straighter, stronger result. For an open-view fence, the finished alignment is part of the job.
Protect exposed metal after the structural work
Chipped coatings and bare steel can develop rust after damage or fabrication. Any repair involving welding, grinding or replacement should include a plan for protecting exposed surfaces. Matching an older powder-coated or painted finish may require additional preparation and will depend on the existing condition.
Iron gates, pools and front-facing fences
Gate posts and hinges see repeated movement, so a dragging metal gate may involve its supporting posts rather than the latch alone. Around pools, repairs must preserve the safety functions of the barrier and gates; a gate that swings or latches incorrectly should be assessed against the applicable requirements before the area is used.
See wrought iron fencing and gate styles →
Frequently asked questions
Can a bent wrought iron fence panel be repaired?
Sometimes. The right approach depends on how severe the bend is, whether welds or connections were damaged, and whether the panel can be restored without leaving the fence visibly out of line.
Do you repair iron or steel fence gates?
Yes. Pecos can repair gate alignment, posts, frames, hinges, latches, and related hardware on wrought iron systems.
Can one damaged steel fence section be replaced?
Yes, when the surrounding posts and panels are in good condition and the replacement can tie back into the existing system cleanly.
Should exposed steel be recoated after repair?
Yes. Areas where coating has been damaged should be protected after structural repair to reduce corrosion risk.